Watch Detective's Guide: Removing the Omega Seamaster Strap Step by Step

Today's watch detective to bring you the Omega Seamaster strap how to remove the sharing, I hope to add new knowledge to you, need to know more about the Omega Seamaster watch can be concerned about theWatchdog website. The Omega-home series ushered in a major change in 2009. The elements of the entire series are very eye-catching. OmegaSeamaster SeriesBorn in 1948, it has gained countless honors around the world with its legendary reputation. Its Seamaster logo represents precision and reliability!

How to remove an Omega watch band.

1. When disassembling the strap, both the left and right sides of the strap are required to be symmetrical, but this does not mean that the number of sections on both sides of the strap must be the same, so the strap folding form is also different, and it is only required that the buckle and the watch are parallel, which is more beautiful.

2. watches like Omega, the new strap buckle buckle is actually biased, so generally only need to remove a section on the strap, basically, unless the wearer's wrist is too thin, if you want to cut off a lot of the strap section, you have to consider intercepting from the ends of the strap. On the inside face of the band is engraved with an arrowhead indicating the orientation of the piercing nails, the installation of the opposite, the top arrow to load.

Steps for removing the strap.

1) Place the strap on the plastic bracket and determine the position to be cut and the direction to thread the pegs.

(2) First use a larger diameter wire punch, vertical to the head of the piercing nails, with a hammer to hit a little length, at this time, pay attention to, under the bracket to leave a hollow, so that the piercing nails can continue to hit out.

(3) Change a smallest diameter of the wire buckle, carefully against the head of the strap, and hammer hard, so that the strap will be broken little by little. If you feel nervous in the process, light hit but wear nail has not come out of the head, you have to stop and observe, there are only two possibilities, one is the wire punch is relatively thick, and then once the punch is not aligned with a good wear nail.

(4) When the piercing nail is smashed to a length of about 1 cm, the piercing needle should be clamped with pliers, pulled out with force, and then separated, and the casing in the strap section should be taken out in time to prevent loss.

(5) When reconnecting the strap, first check that the sleeve is in the strap section. Determine the direction of the piercing nails and the direction in which they were smashed in.

(6) When you first start to put in the nails, you have to hit them directly with a hammer, but when the penetrating nails go through the joint between the two belt sections, you have to check that there is no misalignment, and you can only continue to hit the penetrating nails if you have aligned all their holes.

(7) When the wearing nail is almost broken, at this time to replace the steel wire punch, available thicker punch, such as 1.0 mm, continue to press into the wearing nail, because the diameter of the small steel wire punch, it is very easy to slip, resulting in the appearance of the strap damage.