Complete maintenance guide for Original Factory Collectwatches: common faults and repair procedures

1:1replica watches repair process sharing

Watches are one of the common accessories in daily life, and some expensive and exquisitely crafted watches have collection value. Some Original Factory CollectWatches are almost identical in appearance and function to the original ones, and are even more popular among watch enthusiasts. However, because the quality and workmanship of movement and other components are difficult to guarantee, these watches also face maintenance problems. Let’s discuss the common faults and repair procedures of Original Factory Collectwatches.

Common faults

1. The dial appears to fall off or break, etc.

Most Original Factory Collectwatches use imitation movements, and these movements have quality problems. The movement strength is not strong enough. When the watch is dropped or scratched, the dial can easily fall off or break. In this case, the dial needs to be replaced or re-fixed.

2.movement stall

In the movement of a Original Factory Collectwatch, the friction between the pinion gear and the main gear, the reduction of grease inside the movement, and other reasons will cause the movement to stall. This situation requires replacement or cleaning and re-greasing.

3. The watch has insufficient power or stops

This situation is mostly caused by damage to the movement wire or spring. Corresponding parts need to be replaced.

Maintenance process

Repairing a Original Factory Collectwatch requires us to carry out specific repair work on the watch according to the fault situation. Below we introduce the general maintenance process:

1. Check your watch

First, a series of checks need to be carried out on the watch. Including appearance inspection, function inspection of each component and movement detection, etc.

2. Disassemble the watch

When determining the cause of a watch failure, you need to use the appropriate tools to disassemble the watch. When disassembling the watch, you need to pay attention to the operating specifications to avoid secondary damage to the watch.

3. Replace parts

Depending on the cause of the watch failure, clean or replace the parts that need to be replaced.

4. Install parts

After replacing parts, the watch needs to be assembled. Check each component again and pay attention to whether the bayonet of each part is firmly installed.

5.Adjust time

After reinstalling the watch, you need to adjust the time on the watch. Adjust the hands to the standard position to ensure the accuracy of the watch time.

6. Test

After the watch is completely assembled, it needs to be tested. Including aspects such as the accuracy and reliability of the watch.

Repairing Original Factory Collectwatches requires us to have corresponding technical skills and rich experience. In normal times, we need to pay attention to the maintenance of watches to reduce the occurrence of watch failures. If a malfunction does occur, it is recommended to go to a professional watch shop for repair, or contact qualified maintenance personnel for repair.